Hard Fact and Why Cheap?
Boat dealers try to sell you “big name”, but hey, tinnie is a tinnie, as far as it is strongly built with good hull, what’s the difference. Don’t pay more just for the sticker on the hull, look into the workmanship and material used on the tinnie.
Unlike dealer, We MANUFACTURE and SELL direct to the public (so you are not dealing with middleman!). You simply pay what normally dealer to pay for their dinnie from manufacturer and cheaper!
Cheap Must Be Nasty? NO!
• Most affordable new tinnie in Australia and importantly quality built!
• Beautiful workmanship
♦ Good penetration of welding, no needle hole, no under-cutting, MIG welded/TIG repaired. Don’t just look at the weld appearance, look at PENETRATION! That’s how you stop later endless warranty nightmare
♦ Every single boat water leaking tested (by submerse the chine and keel in the water tank ) prior leaving factory
♦ Good and clean work on fit-outs (look at carpeting and floor work)
♦ Sound structural work (no gap in between bottom rib and hull, foam installed in between preventing annoying noise and vibration)
• Level flotation
(Look at Builders’ Plate) with Polyurethane buoyancy foam (not CHEAP Polystyrene foam which should be packing the fridge not float a boat)
• Legendary hull design
(V nose to chop water to gain high speed, flat hull to provide stability on water), our hull is designed by alloy boat designer who worked in industry for more than 30 years!
• Super strong structure
♦ 4 side ribs compare to “Leading Manufacturer” ‘s 2 side ribs
♦ Seat welded onto the rib, not riveted! This is also how you maintain tinnie beam width and ensure hull not twisted!
♦ Heavy Duty extrusion used to ensure transom stability even you decided to put bigger OB to go wild
♦ Foam block tight with seat, doesn’t rattle
• When things go wrong
Ask yourself, when your boat get problem, can dealer weld it up for you in your city? Or you need to fill in the form, get approved, send back to factory (remember freight will be paid by yourself!), wait a few months and get back. Why go through all these pain and bull! MW has factory with qualified welder in Brisbane, Melbourne, Sydney. Even in Perth and Adelaide, we have contractor welder working for us. Your warranty will be well looked after in your area.
We also manufacture and sell centre-line 4.3 meter trailer to suit these tinnie, check it out!
Warranty: 3 year limited hull warranty
Who are we?
MW Toolbox & Trailer Centre is Australia largest Aluminium Toolbox/Canopy/Trailer manufacturer and retailer, manufacturing over tens of thousands of products each year. MW’s products are known for its design, toughness and excellent warranty/customer service.
100% positive feedback ebay-er and we operate 26 retail shops nation-wide, not a buy-in buy-out middle-man operating from the backyard. Buy with confidence from a reputable business.